Morning...noticed that heating Elements are working, but the fan motor is not turning on. I go to the Thermostat and move the contact lever up and down and there is no spark when the contacts meet. When I go through moving the wiring around and pulling on and off the wires to their connectors...then...

Thank you Robert...I will be ordering the sequencer and limits soon. Have a good day...God bless you.

Robert...what part number is for a limit switch...that is used in a EB17B furnace that uses a 3115-357 sequencer? The limit switches are used on heating element packages Part numbers 3500-412, and 3500-405. The limiters in this furnace is made of a white ceramic material, and are held down by only O...

Good morning from Dahlonega, Ga....I have a 1995 EB17 with 240v output on both breakers, and all three heating coils read the same low ohms...however, only one (1) coil out of three (3) has 240 volts at the coils...whatcha think? Went back and checked the ohms across the coil contacts where the wire...

Thanks Robert--Humbly Grateful...have a wonderful and blessed new year and may God watch over and protect your family.

Does the EB17B Furnace have a Blower Fan Relay and if it does, where is it located on the furnace?

Just found the problem...I looked over the Lower Control Board 7681-317P, and I spotted a loose resistor joint where the solder meets the resistor lead. Resoldered the loose joint and the unit is working fine again.

Just started last night-- woke this morning to a cold home...went to the furnace and it was warm standing by the unit...opened unit...hot around heating elements and sheet metal, but no running fan. Went to the thermostat and rocked the control arm up-and-down several times listening to the clicks.....

Does any one know what type of 18 pin, U1 integrated circuit (ic) is used on this Coleman Lower Control Board? I have a blown chip and I believe if I replace this chip, my problem might be solved.