gas coleman evcon
The Furance wont light . The indacator light doesnt really flash,it goes off and on real fast . Sometimes you can flip the switch and it will run 1 time when it stops you have to knock power and start over. I was thinking control board what do you guys think .Thanks ps m#dgato70bdd electricman
Hi,
It should be showing a flash signal from one to six flashes/blinks.
When it doesn't work, does it do anything or does anything work on a call for heat ?
I wouldn't replace something as costly as a board without being sure.
Thanks,
Robert
It should be showing a flash signal from one to six flashes/blinks.
When it doesn't work, does it do anything or does anything work on a call for heat ?
I wouldn't replace something as costly as a board without being sure.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
Robert, Thanks for your reply the light wasnt giving a study code more like a flashing . I changed the board and it is working ok. Thanks again for your reply.Im still new to the trade but learning more every day,with help from guys like you. THANKS A LOT :)
Hi,
That's great and you're very welcome. Hope all stays good to go with it.
Take care and best wishes,
Robert
That's great and you're very welcome. Hope all stays good to go with it.
Take care and best wishes,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 110046 Views
-
Last post by cwwhite75
Sat Feb 29, 2020 8:46 am
-
-
I am thinking of switching to a gas water heater
by deryk the gypsy » Sat Jul 22, 2017 7:16 am » in Mobile Home Repair - 2 Replies
- 39159 Views
-
Last post by Greg
Sat Jul 22, 2017 12:26 pm
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49079 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74894 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
- 0 Replies
- 42046 Views
-
Last post by David DeBord
Sun Oct 22, 2017 7:13 am