new thermostat
I have a coleman presidential 3 furnace. I just replaced the old manual thermostat with a new digital programmable hunter thermostat. I was told that if I left the digital thermostat on the heat setting, everything would work fine since I have to switch between heat and cool on the furnace unit itself. However, when I turn the switch on the furnace to cool, the blower turns on regardless of what temperature the thermostat is set at. I don't know if the a/c outside turns on or not. When I am heating my mobile home, everything runs normally. This is a two wire system. Any suggestions? (Wiring is r-r, w-w with a jumper between rh-rc)
Hi,
When the furnace mode switch is set to Cool, the inside blower motor and outside Condenser Unit should come on immediately.
May be nothing wrong.
Is the new t-stat battery operated ?
How many control boxes are inside your furnace ?
Is there a Transformer mounted inside controls area of outside Condenser Unit ?
Check also and see if outside Condenser is running when the inside blower comes on when switched to Cool.
Take care and best wishes,
Robert
When the furnace mode switch is set to Cool, the inside blower motor and outside Condenser Unit should come on immediately.
May be nothing wrong.
Is the new t-stat battery operated ?
How many control boxes are inside your furnace ?
Is there a Transformer mounted inside controls area of outside Condenser Unit ?
Check also and see if outside Condenser is running when the inside blower comes on when switched to Cool.
Take care and best wishes,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Installing Honeywell Lyric T5 Smart Thermostat
by TomAllyn » Sun Dec 29, 2019 12:07 pm » in Coleman Service & Repair - 1 Replies
- 19302 Views
-
Last post by TomAllyn
Sun Dec 29, 2019 2:13 pm
-
-
- 4 Replies
- 16927 Views
-
Last post by Norm Frechette
Tue Mar 17, 2020 8:30 am
-
-
Nordyne M1B1 furnace issue - thermostat c wire not hooked up correctly. It's running off atteries instead
by Tallestt » Mon Apr 20, 2020 6:27 am » in Nordyne Service & Repair - 1 Replies
- 43347 Views
-
Last post by taurolyon
Tue Jun 23, 2020 4:02 pm
-
-
- 2 Replies
- 50857 Views
-
Last post by Mark440
Thu Apr 11, 2019 11:15 am
-
-
New Deck and Porch coming (photos included)
by vilmel2vilmel2 » Mon Jul 17, 2017 5:58 pm » in Mobile Home Repair - 4 Replies
- 44268 Views
-
Last post by vilmel2vilmel2
Wed Aug 02, 2017 10:29 am
-