Hi, I have a M#DGAA0707BDTA Coleman furnace. I actually think the pressure switch is bad, so I ordered one of those. However, I was wondering how one removes the blower assembly on this unit? I originally thought the blower might be the problem, but the fan is running at the rated amps, the tubes to the switch are clear, and neither port on the assembly is blocked. As I looked at this assembly, I could not figure out how I'd remove it, if I had to. Any advice? Thanks!
Rahat801
Removing booster assembly
Go below to gas valve and the assembly where the screws are around the perimeter. You remove those to remove assembly so that the booster assembly drops down.
Tilt out and then remove it upward.
Thanks,
Robert
Tilt out and then remove it upward.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
Good Morning,
Thank you for the direction! It looked like that would be what I would have to do, but sometimes things are not what they look like!! : )
Thanks again!
Rah
Thank you for the direction! It looked like that would be what I would have to do, but sometimes things are not what they look like!! : )
Thanks again!
Rah
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 9135 Views
-
Last post by Greg
Fri Jan 26, 2018 7:55 pm
-
-
Removing fireplace in doublewide
by Twinparent924 » Thu Nov 08, 2018 10:53 pm » in Mobile Home Repair - 1 Replies
- 19873 Views
-
Last post by Greg
Fri Nov 09, 2018 7:38 pm
-
-
- 3 Replies
- 12274 Views
-
Last post by Greg
Wed May 22, 2019 6:28 pm
-
-
Removing the seem strips on the walls
by J_SEPH0729 » Mon Sep 30, 2019 9:01 am » in Mobile Home Repair - 2 Replies
- 10864 Views
-
Last post by J_SEPH0729
Tue Oct 01, 2019 8:15 am
-
-
- 1 Replies
- 28927 Views
-
Last post by Mark440
Sat Dec 05, 2020 2:03 pm