Thermostat heat anticipator setting?
-
- Posts: 17
- Joined: Fri Feb 01, 2008 5:59 am
What is a good setting for the heat anticipator? Is there any rule of thumb for where it should be set or is it kinda of wing it thing? Thanks :?:
- flcruising
- Posts: 606
- Joined: Mon Dec 03, 2007 2:18 pm
- Location: Florida Panhandle
What type of thermostat and furnace?
If gas furnace, you typically match the milliamp draw of the gas valve, then adjust incrementally (shorter or longer) from there depending what cycle frequency you're aiming for.
If gas furnace, you typically match the milliamp draw of the gas valve, then adjust incrementally (shorter or longer) from there depending what cycle frequency you're aiming for.
[color=blue]Aaron[/color]
-
- Posts: 17
- Joined: Fri Feb 01, 2008 5:59 am
Intertherm Gas furnace and Intertherm thermostat.
Look in your furnace manual or on the gas valve for the anticipator amp setting, then set accordingly and leave it there.
Needs to be set to manufacturer design specs and left there with no adjustments needed.
Thanks,
Robert
Needs to be set to manufacturer design specs and left there with no adjustments needed.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Installing Honeywell Lyric T5 Smart Thermostat
by TomAllyn » Sun Dec 29, 2019 12:07 pm » in Coleman Service & Repair - 1 Replies
- 19300 Views
-
Last post by TomAllyn
Sun Dec 29, 2019 2:13 pm
-
-
- 4 Replies
- 16920 Views
-
Last post by Norm Frechette
Tue Mar 17, 2020 8:30 am
-
-
Nordyne M1B1 furnace issue - thermostat c wire not hooked up correctly. It's running off atteries instead
by Tallestt » Mon Apr 20, 2020 6:27 am » in Nordyne Service & Repair - 1 Replies
- 43346 Views
-
Last post by taurolyon
Tue Jun 23, 2020 4:02 pm
-
-
- 0 Replies
- 23707 Views
-
Last post by nestsman
Sat Aug 19, 2017 1:47 pm
-
-
intertherm standing pilot propane burner Heat Rise of 38°F spread.
by justplumducky » Fri Aug 25, 2017 10:06 am » in Nordyne Service & Repair - 0 Replies
- 55118 Views
-
Last post by justplumducky
Fri Aug 25, 2017 10:06 am
-