Hi Mark,
A contractor installed Nordyne Furnace Model # KG7SK 108N-35C Serial # KGD080401959 in January 2009.
It was working fine, but this week when I turned it on it works but there is no heat, and it doesn't stop, I have to lower the Termostat to stop it.
Any advise will be great.
Thanks,
There is no HEAT.
-
- Posts: 23
- Joined: Fri Oct 09, 2009 11:07 am
I assume that u mean the blower is running but u get no hot air from your vents, am i on the right track?
-
- Posts: 2
- Joined: Thu Oct 08, 2009 10:11 pm
Yes, you are right.
But I opened the furnace and I found that the fun started to work for about a minute and stoped, and still hear the air sound.
thanks,
But I opened the furnace and I found that the fun started to work for about a minute and stoped, and still hear the air sound.
thanks,
Hi,
Check your main burner orifice and orifice spud for blockage from spider/web and also check the burner tube for any blockages.
Are you in a single or double or triple wide ?
Thanks,
Robert
Check your main burner orifice and orifice spud for blockage from spider/web and also check the burner tube for any blockages.
Are you in a single or double or triple wide ?
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
A message to the MH builders out there
by Mark440 » Sat Oct 10, 2020 1:37 pm » in Mobile Home Repair - 3 Replies
- 43187 Views
-
Last post by Mark440
Sat Oct 10, 2020 7:31 pm
-
-
- 0 Replies
- 23738 Views
-
Last post by nestsman
Sat Aug 19, 2017 1:47 pm
-
-
intertherm standing pilot propane burner Heat Rise of 38°F spread.
by justplumducky » Fri Aug 25, 2017 10:06 am » in Nordyne Service & Repair - 0 Replies
- 55205 Views
-
Last post by justplumducky
Fri Aug 25, 2017 10:06 am
-
-
-
Acceptable HEAT RISE number for this 20-yr. old furnace.
by justplumducky » Tue Aug 29, 2017 5:33 pm » in Nordyne Service & Repair - 0 Replies
- 44475 Views
-
Last post by justplumducky
Tue Aug 29, 2017 5:33 pm
-
-
- 0 Replies
- 42125 Views
-
Last post by David DeBord
Sun Oct 22, 2017 7:13 am