Nat gas to lp conversion question
I havea amiller furnace mod: M1MB 070a BW. It is using a 7200 DERC Robert Shaw gas valve. How can i tell if the unit has been converted to lp....? I see it has a valve marked nat gas on one end an lp on the other. It is currently showing the red stripe end pointing away from the valve..? Is this correct. ? What is the correct procedured to change over this valve, and does it need a conversion kit... I just obtained this home and the previous owners were using propane, but the flame just desnt look right...
Is Nat. Gas or LP upright and legible ?
You invert the conversion stem for gas being used, replace orifice for gas used and change gas pressure for same.
If you believe it may be wrong, call an hvac tech to inspect it.
Thanks,
Robert
You invert the conversion stem for gas being used, replace orifice for gas used and change gas pressure for same.
If you believe it may be wrong, call an hvac tech to inspect it.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
I am thinking of switching to a gas water heater
by deryk the gypsy » Sat Jul 22, 2017 7:16 am » in Mobile Home Repair - 2 Replies
- 39191 Views
-
Last post by Greg
Sat Jul 22, 2017 12:26 pm
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49145 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74961 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
- 0 Replies
- 42125 Views
-
Last post by David DeBord
Sun Oct 22, 2017 7:13 am
-
-
Replace Roof Sheathing and Truss Question
by MandMLawson » Mon Aug 28, 2017 9:16 am » in Mobile Home Repair - 4 Replies
- 37165 Views
-
Last post by Jim from Canada
Wed Aug 30, 2017 10:09 am
-