I had to repair the Draft inducer motor on my CMF100 Furnace. Mine as a simple shudder adjustment that controls/limits the amount of draft air pulled in to the motor. I need instructions on adjusting this shudder. The furnace makes a low-pitched "rumbling" noise indicating poor combustion. I need to adjust this properly for complete combustion, efficiency and proper heat output. The photo size is large, but I am pointing to the "shudder" that needs adjustment.
Thanks,
Mike
Need Help for Miller CMF100-PG-DI-N
-
- Posts: 1
- Joined: Wed Dec 30, 2009 2:24 pm
You do not have the required permissions to view the files attached to this post.
Hi Mike,
You would set it to allow for a clean blue burner flame and correct temp rise as given on the nameplate for furnace specs.
If you are having difficulty with getting it right, call an hvac tech out to set it for you.
Thanks,
Robert
You would set it to allow for a clean blue burner flame and correct temp rise as given on the nameplate for furnace specs.
If you are having difficulty with getting it right, call an hvac tech out to set it for you.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
I need wiring assistance for a miller furnace serial number A0981-0685
by Timodell » Wed Nov 20, 2019 10:40 pm » in Nordyne Service & Repair - 0 Replies
- 65748 Views
-
Last post by Timodell
Wed Nov 20, 2019 10:40 pm
-
-
-
Need help identifying manufacturer of back door
by nestsman » Mon Oct 09, 2017 11:25 am » in Mobile Home Repair - 2 Replies
- 22955 Views
-
Last post by UmpJJ
Wed Oct 18, 2017 8:48 am
-
-
-
Home is shifting and sinking - Need help!
by Catherine405 » Tue May 29, 2018 1:35 pm » in Mobile Home Repair - 3 Replies
- 11597 Views
-
Last post by Greg
Wed May 30, 2018 7:58 pm
-
-
- 5 Replies
- 16082 Views
-
Last post by Greg
Thu Oct 18, 2018 7:38 pm
-
-
Sagging floor under toilet, need help with size of shutoff fittings
by ferret13sj » Thu Nov 17, 2022 9:37 pm » in Mobile Home Repair - 4 Replies
- 63420 Views
-
Last post by yakima4$
Thu Dec 01, 2022 11:16 pm
-