coleman deluxe belnd air II system flashing light
-
- Posts: 1
- Joined: Tue Jan 05, 2010 7:47 pm
I used your trouble shooting guide for my deluxe blend air II system. It worked really well. I found that the upper board had burned out. It actually looked a little burned. I replaced both the upper and lower boards. Everything else on the troubleshooting checks out just fine, however, the red flashing light is still on. A power surge is what caused the problem with the upper board. The blower motor on the roof is working, as it blows air and stops and starts. However, I suspect it may have been damaged from the power surge too. Is it possible that a voltage drop or other damage to the blower motor is causing the flashing light? I am stumped!
Sometimes those things have a mind of their own. With a new board, if it is still flashing I would go back over each step to see if anything was missed.
Thanks,
Robert
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 24378 Views
-
Last post by Greg
Sat Jul 29, 2017 7:14 pm
-
-
Electrical outlets that are linked to a light switch
by nestsman » Sat Mar 03, 2018 6:32 pm » in Mobile Home Repair - 4 Replies
- 28836 Views
-
Last post by Greg
Mon Mar 05, 2018 6:04 pm
-
-
-
Hanging a non hard wired light, how heavy?
by Carlo.clausen » Mon Jun 15, 2020 9:40 pm » in Mobile Home Repair - 1 Replies
- 12502 Views
-
Last post by Greg
Tue Jun 16, 2020 4:14 pm
-
-
-
Water coming in through bathroom light / vent
by mobtek » Wed Jun 24, 2020 2:38 pm » in Mobile Home Repair - 1 Replies
- 8148 Views
-
Last post by Greg
Wed Jun 24, 2020 4:46 pm
-
-
-
DGAT Series furnace air-conditioning issue
by minnie1967 » Thu Jul 13, 2017 9:48 am » in Coleman Service & Repair - 0 Replies
- 61983 Views
-
Last post by minnie1967
Thu Jul 13, 2017 9:48 am
-