Coleman DGAA070BDTA Flame goes out as soon as blower starts
I have a Coleman DGAA070BDTA Propane furnace. It has worked all winter until this morning. When turning it on, after around ten seconds I can see it start to glow through the view hole. After around 5-10 more seconds the flames appear. After around 15 seconds more the blower kicks on and the flames go out. Any suggestions would be greatly appreciated. Thanks!
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 25777 Views
-
Last post by Tonystark
Fri Dec 07, 2018 12:30 pm
-
-
Unit Starts then Stops - Ignition Failure
by Arkady78 » Wed Dec 02, 2020 9:58 am » in Coleman Service & Repair - 0 Replies
- 104779 Views
-
Last post by Arkady78
Wed Dec 02, 2020 9:58 am
-
-
-
Model DGAA070BDTA venting kit needed.
by spazatac » Fri May 24, 2024 11:21 am » in Coleman Service & Repair - 2 Replies
- 780 Views
-
Last post by spazatac
Mon Jun 10, 2024 3:11 pm
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 116538 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49145 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-