Miller/nordyne M1BB 086A BW
Turn termostat on and nothing happens, power to the furnace but no noises f anythign trying to start and no led lights on the UE 1018 hot surface ignightor which should be flashing something. Tells me the board must be bad
what are your thoughts???
Thanks
Dana
M1BB 086A BW gas furnace Wont Start
After taking the cover off where the coil and transformer are I found the 3a fuse on the red wire going coming from the thermastat to the transformer was blown, changed it turned power on and the thermastat made a cranckling noise like it fried itself and the fuse didnt blow but got very warm and the transformer 621807 got very very warm
Last edited by dblacks on Mon Feb 15, 2010 1:12 pm, edited 1 time in total.
There is a short somewhere in the low voltage circuit. Get an hvac tech out to locate it for safety as it is a fire hazard.
Thanks,
Robert
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
i got my tester back frm my buddy and tested everything, turned out to be the centrifical switch in the motor shorted so I had to get a new motor, motor would run when I bypassed the modul thou so it was just the switch coming from the module, thanks anyways.
Odd thing is the short blew the fuse but also blue the transformer and the cheapo T-Stat.
Odd thing is the short blew the fuse but also blue the transformer and the cheapo T-Stat.
Glad you found it. T-Stat and xfmr probably got hot before fuse blew. Second time they finished off before fuse blew.
Take care and best wishes,
Robert
Take care and best wishes,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
3500A816 Randomly wont start or shut down
by Smithcraft » Fri Jan 13, 2023 4:04 pm » in Coleman Service & Repair - 0 Replies
- 95183 Views
-
Last post by Smithcraft
Fri Jan 13, 2023 4:04 pm
-
-
- 14 Replies
- 162461 Views
-
Last post by Greg
Tue Sep 26, 2017 1:00 pm
-
-
I am thinking of switching to a gas water heater
by deryk the gypsy » Sat Jul 22, 2017 7:16 am » in Mobile Home Repair - 2 Replies
- 39175 Views
-
Last post by Greg
Sat Jul 22, 2017 12:26 pm
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49135 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74935 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-