Everything seemed to be working fine, I smelt the little gas that I'd assume would've been used for the pilot? But there was no activity in the chamber. After 3 or 4 failed attempts by the furnace to lite I received the LED warning.
Sry about the confusion, the "main piece" as I'm defining it for this issue is the apparatus that the main gasline goes into and it also has the red gas primer type switch, I've experienced the spider webs before, the reason i ask for the quote is the last time I had to replace the "main piece" because they got past the the inner "really-fine" screen.
Back to the current problem at hand tho, I had two different sets of channel locks try without success to disconnect the flexhose (from the main gas line) from the "main piece". Should I just give-her-hell or do u have a more subtile approach I could try? I'm probably being too cautious but I just want to make sure I don't cause a minor problem that could be much bigger later
Thanks for your help