We have some four payne, mobile home aluminum frame, jalosy crank out type windows. The individual glass paynes have some kind of aluminum trim about 3/4" wide that appears to hold the glass payne in the individual window frames. Some of the glass paynes are cracked and need to be replaced. Is this something a novice can do?
What are the steps required to replace the individual paynes?
Can the aluminum trim be re-used to hold the new glass in place or should something different be used?
How tough of a job is it to replace the glass paynes?
Thanks, Dave
How To Replace Window Glass Payne??
Moderators: Greg, Mark, mhrAJ333, JD
If you look close at the window you should see where the hinge is attached to the frame holding the Payne. If it is screwed on you should be able remove the Payne & it's frame from the window In the corners of the small frame there should be screws that hold it together. Remove them and you should be able to replace the glass. If not you can take it to a glass shop or hardware store for them to do it. Greg
"If I can't fix it, I can screw it up so bad no one else can either."
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 2096 Views
-
Last post by Greg
Wed Jun 19, 2019 5:23 pm
-
-
Replace Roof Sheathing and Truss Question
by MandMLawson » Mon Aug 28, 2017 9:16 am » in Mobile Home Repair - 4 Replies
- 37127 Views
-
Last post by Jim from Canada
Wed Aug 30, 2017 10:09 am
-
-
- 0 Replies
- 13851 Views
-
Last post by Oregon101
Wed Mar 21, 2018 11:23 am
-
-
how do I replace a front door with built in storm door?
by truckinusa » Thu Oct 18, 2018 9:30 pm » in Mobile Home Repair - 0 Replies
- 35856 Views
-
Last post by truckinusa
Thu Oct 18, 2018 9:30 pm
-
-
-
Replace relay for Emergency. Heat in E2EB-15HB
by istvv4848 » Tue Oct 23, 2018 10:49 am » in Nordyne Service & Repair - 0 Replies
- 44262 Views
-
Last post by istvv4848
Tue Oct 23, 2018 10:49 am
-