I have a Coleman 76803856 LP ran furnace and would like to know how to adjust the gas pressure in the gas valve on the furnace, here is a picture, they say a spring can get weak and increase the gas pressure. Is it behind the hex plug above the rotary on/off vale in the picture? Thanks!
Gas Pressure
Hi,
Adjusting gas pressure should only be done by an hvac tech and is not recommended for DIY.
Gas Valve # 7956 - 336P can be seen and ordered here by paging down :
http://www.aberdeenhomerepair.com/store ... -gas-valve
Will most likely also need Mounting Bracket # 7705 - 5101.
After adding gas valve to cart, type mounting bracket p/n into search window.
The gas valve is the correct replacement, but will not look like the old one and may or may not have same piping configurations.
Thanks,
Robert
Adjusting gas pressure should only be done by an hvac tech and is not recommended for DIY.
Gas Valve # 7956 - 336P can be seen and ordered here by paging down :
http://www.aberdeenhomerepair.com/store ... -gas-valve
Will most likely also need Mounting Bracket # 7705 - 5101.
After adding gas valve to cart, type mounting bracket p/n into search window.
The gas valve is the correct replacement, but will not look like the old one and may or may not have same piping configurations.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
I am thinking of switching to a gas water heater
by deryk the gypsy » Sat Jul 22, 2017 7:16 am » in Mobile Home Repair - 2 Replies
- 39159 Views
-
Last post by Greg
Sat Jul 22, 2017 12:26 pm
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49079 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74895 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
- 0 Replies
- 42047 Views
-
Last post by David DeBord
Sun Oct 22, 2017 7:13 am