sheet rock, just wonderin
Moderators: Greg, Mark, mhrAJ333, JD
I've been doing some sheet rock on my 2 m/h and the thought occured to me when i was adding a wall in the kitcken. does it matter witch way you hang the sheet? i mean vertical or horizontal. the walls i put up are partition walls but they also hold up the kitshen wall cabs. i used 2x4 for the frame and 1/2" sheet . the wall is about 9 'long by 8' at the peak. so i used 4, 4x10 sheet and hung them horizontal. finished the seam and when primed and painted you couldn't tell where the seam was. been 3 years and with an active washing machine in the next room no crackes have been seen, yet the vertical panels that i filled and sanded have cracks in them. did this all at the same time. was it just my dumd luck or am i on to something with this method? thanks joe.
"a man has got to know his limitations", clint eastwood. " i haven't found mine yet," me
Well Joe, You should have less seams showing horizontal than vertical. And personally I think it is easier to sand a 4' seam than a 7'.Many sheet rock hangers use this method.
Greg
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Reil Rock Skirting - question about install
by amymarie7923 » Mon Nov 05, 2018 9:10 am » in Mobile Home Repair - 4 Replies
- 54372 Views
-
Last post by Mark440
Sun Nov 18, 2018 11:41 am
-