furnace vent
Moderators: Greg, Mark, mhrAJ333, JD
Just replaced my roof furnace vent cover due to rust & unstable. It was fairly close to the roof where it was attached.I put a 2ft w/cover pipe on.It's inset approx. 4" and pipe sealant applied to prevent water leakage. My question is -- will it make a difference on the furnace with the extra highth replacement ?
-
- Posts: 383
- Joined: Mon Oct 25, 2010 9:53 pm
- Location: Steuben County, NY
No, the height should not make a difference. I had to raise the vent on my gas water heater to get it above the roof peak to prevent wind from extinguishing the pilot.
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 3585 Views
-
Last post by Greg
Sun Oct 14, 2018 8:41 am
-
-
Doublewide - Vent or Leave roof Non-vented?
by 73Viking » Fri Jun 14, 2019 7:00 pm » in Mobile Home Repair - 2 Replies
- 11567 Views
-
Last post by 73Viking
Sat Jul 13, 2019 12:21 pm
-
-
- 3 Replies
- 3183 Views
-
Last post by Greg
Thu Aug 22, 2019 6:56 pm
-
- 0 Replies
- 88977 Views
-
Last post by jacklynbotsford
Wed May 20, 2020 10:00 am
-
-
Water coming in through bathroom light / vent
by mobtek » Wed Jun 24, 2020 2:38 pm » in Mobile Home Repair - 1 Replies
- 8140 Views
-
Last post by Greg
Wed Jun 24, 2020 4:46 pm
-