So the weather is beginning to turn cool in south Louisiana. Woke up to 59 degrees in the house. I like it, but my kids and wife don't. So, I turn on the heater. Typically, after about 8 seconds or so, the unit "clicks" and the heater comes on. I wait 60 seconds...5 minutes....still nothing. The unit never clicked and the blower never came on. The A/C works fine, however.
Any idea what's going on and how to fix it?
I have a Coleman EB15B
Thanks,
Jay
A/C Works, Heat and Blower Don't
Without the system in front of me you could have a 2 transformer system. That 26 sounds right, minimum is 24. Check your sequencer. Once you turn the tstat to heat and high enough for it to start the sequencer should get 24 volts to it. It will then cycle the furncae through it's paces. If 24 is at sequencer and nothing happens I would replace the sequencer.
Thanks again, Dale. I appreciate the help.
Here is a link to a manual I scrapped together from internet pics. I made a PDF out of it. Does this help you? See page 13.
http://db.tt/TE8804on
Here is a link to a manual I scrapped together from internet pics. I made a PDF out of it. Does this help you? See page 13.
http://db.tt/TE8804on
Check to see what voltage you have at the sequencer between H1 and H2 as well as H3 and H4. If 24 volts present at each of those connections then the sequencer is most likely bad. Once control voltage (24v) is put to the coil on the sequencer, thermodiscs activate the blower circuit and the heating elements to come on "sequentially".
-
- Similar Topics
- Replies
- Views
- Last post
-
- 2 Replies
- 32802 Views
-
Last post by Mark440
Mon Jul 05, 2021 9:43 am
-
-
HVAC duct redirect - IT WORKS !
by Mark440 » Mon Jul 01, 2019 11:30 am » in All Other HVAC Questions - 0 Replies
- 30875 Views
-
Last post by Mark440
Mon Jul 01, 2019 11:30 am
-
-
-
A/C and heat comes from the ceiling vents. Are the existing floor vents necessary?
by NanaMary » Tue Nov 21, 2017 12:35 pm » in All Other HVAC Questions - 2 Replies
- 55492 Views
-
Last post by NanaMary
Fri Nov 24, 2017 11:14 am
-
-
-
Heat exchanger walls and floor all sooted up.
by plumducky » Sat Jan 25, 2020 5:05 pm » in Coleman Service & Repair - 1 Replies
- 28730 Views
-
Last post by Filkinson
Tue Feb 18, 2020 9:01 am
-
-
- 0 Replies
- 65430 Views
-
Last post by Chevy357
Wed Nov 13, 2019 7:47 pm