I have a miller gas furnace model MMHA-056ABHR-01. Furnace not running, will not even start. Replaced t-stat and still will not start. checked power to unit - power is on fan will run if you turn on fan switch. dont know if it is the control module or what any ideas?
thanks, rb
miller gas furnace
Okay put furnace switch to off. Disconnect all the thermostat wires at the furnace. Connect red and white thermostat wires from furnace together. Turn furnace switch to ON. Furnace should start a cycle. If not, check to see if you have 24 volts coming from transformer. If you do not have 24 volts from transformer replace it. If you do have 24 volts from transformer problem is in either the wiring to the thermostat or the thermostat itself. Just for a test, hang a heat only thermostat from a nail with about 15-20 feet of thermostat wire connecting it to the furnace. Test run it like that for a while.
Does your combustion motor start? If not kill power to the furnace, look at small black motor on lower right side of unit. You can see small fan fins through the motor vents. Take a small screwdriver and turn those fins. They should move easily. There are times once you move that motor it will start up.
That motor has to start first before anything else will happen.
That motor has to start first before anything else will happen.
History on furnace, last year my dad started the furnace and it reached temp but would not shut down so he tried to turn off furnace at tstat, that did not shut it down. Furnace kept running and heating so he finally went to the breaker and shut down the power. When he went to start this year nothing would run. I tried several times to turn the combustion motor and it turned fine, was not froze up and spun ok, but furnace would not start. Next????? Thank you for all your patience!
If the unit was in full burn when he shut it down a limit switch may be out. Check all your limit switches. First look at them to see if they are resettable. There will be a little button right between the terminals. If you see one push it down hard. If not manual reset, pull them and test with a continuity tester, they should be closed, if open replace it/them.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
I need wiring assistance for a miller furnace serial number A0981-0685
by Timodell » Wed Nov 20, 2019 10:40 pm » in Nordyne Service & Repair - 0 Replies
- 65682 Views
-
Last post by Timodell
Wed Nov 20, 2019 10:40 pm
-
-
-
have intertherm heat pump with a 913421 control box tying to a miller 841 thermo stat ,
by hillcat01 » Mon Oct 21, 2019 7:28 pm » in Nordyne Service & Repair - 0 Replies
- 86924 Views
-
Last post by hillcat01
Mon Oct 21, 2019 7:28 pm
-
-
-
Fluctuating flue draft Miller CMF2 80 PO CONV
by ctwap2783 » Sat Feb 22, 2020 9:36 pm » in Nordyne Service & Repair - 0 Replies
- 122961 Views
-
Last post by ctwap2783
Sat Feb 22, 2020 9:36 pm
-
-
- 0 Replies
- 132444 Views
-
Last post by wogman75
Tue Jul 28, 2020 2:43 pm
-
-
I am thinking of switching to a gas water heater
by deryk the gypsy » Sat Jul 22, 2017 7:16 am » in Mobile Home Repair - 2 Replies
- 39154 Views
-
Last post by Greg
Sat Jul 22, 2017 12:26 pm
-