My 1974 mobile home has a good porch roof that is corrugated and has nice pink stars printed on the underside. It appears sturdy enough to support a 4 by 8 sheet of plywood 1/2 inch thick or more. I need to go out on the roof to clean up and seal up the metal flashing that is at a 45 degree angle from the edge of the home roof down to the surface of a flat steel plate over the corrugated pieces.
Pictures are here - http://thorwaldsonwholehousefans.com/bl ... orch-roof/
Porch roof - can I put plywood on it to support me?
Moderators: Greg, Mark, mhrAJ333, JD
Tough to say for sure. If you add a sheet of plywood I would be concerned about the sheet sliding off of the roof with you on it.
Is it possible to come over the top from the other side?
Greg
Is it possible to come over the top from the other side?
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
-
- Similar Topics
- Replies
- Views
- Last post
-
- 1 Replies
- 29990 Views
-
Last post by Greg
Mon May 06, 2019 6:09 pm
-
-
New Deck and Porch coming (photos included)
by vilmel2vilmel2 » Mon Jul 17, 2017 5:58 pm » in Mobile Home Repair - 4 Replies
- 44265 Views
-
Last post by vilmel2vilmel2
Wed Aug 02, 2017 10:29 am
-
-
-
Deck footing and porch design questions
by mdnagel » Thu Aug 15, 2019 1:28 pm » in Mobile Home Repair - 6 Replies
- 33264 Views
-
Last post by mdnagel
Tue Aug 20, 2019 6:44 pm
-
-
-
Can't read MFD size on rusted dual run cap.
by justplumducky » Sat Jul 01, 2017 6:31 pm » in Nordyne Service & Repair - 0 Replies
- 46694 Views
-
Last post by justplumducky
Sat Jul 01, 2017 6:31 pm
-
-
-
Can't get the furnace cover to go on
by nestsman » Sat Sep 30, 2017 4:53 pm » in Nordyne Service & Repair - 2 Replies
- 48439 Views
-
Last post by tkrueger
Sat May 05, 2018 9:12 pm
-