Has anybody used one of these wifi thermometer/humidity digital units and placed one of the sensors under the house? While humidity is always a concern - it would be nice to know what the temp is down under - especially during the winter. I'm hoping I can find one that starts beeping if a low temperature threshold happens.
I've never had a water line freeze up - but I always 'worry' all the same. I understand some of the units have up to 3 channels so you can do inside, outside, and then down under. Pricing is ~ $25 (+additional sensors)
Wifi belly side temperature monitor
Moderators: Greg, Mark, mhrAJ333, JD
I found one on Amazon that looks like it will work well - and it has a very good 4.5 star rating. It is 3 outdoor channels + indoor temp+humidity. The 3 outdoor channels will allow me to put one outside, one in my workshop, and put one under the house.
I'll update this post after installing and using for a week or two.
On Amazon: ORIA Indoor Outdoor Thermometer with 3 Wireless Sensors, Digital Hygrometer Thermometer, Temperature Humidity Monitor Meter with LCD Backlight, Wireless Thermometer
I'll update this post after installing and using for a week or two.
On Amazon: ORIA Indoor Outdoor Thermometer with 3 Wireless Sensors, Digital Hygrometer Thermometer, Temperature Humidity Monitor Meter with LCD Backlight, Wireless Thermometer
Opportunity has a shelf life.
Ok...got the unit today and immediately set it up. It is literally just installing batteries and that's it. (NOTE: each sender uses 2 of the AAA's....so 6 total, and the receiver unit users 3 of the AAA's)(total of 9 batteries) FWIW - install the batteries in the senders first. Then the main unit. Give it a couple minutes and the senders will start reporting in.
Thermostat on the HVAC is at 74°. indoor temp on the unit is reading 73.6°.
The #1 sender unit is setting on my breakfast table and it shows 73.7°
I put a sender in the workshop (#2) and one down under (#3).
Workshop is showing 48.3°. Local remote weather station shows 46°.
The down under is showing 54°...and i have nothing to compare it to.
What's really nice about this is ALL of the info is showing on one device - ALL at the same time.
All told, unit +batteries, I spent ~$43. The data is such a relief. (Knowledge is power!)
Thermostat on the HVAC is at 74°. indoor temp on the unit is reading 73.6°.
The #1 sender unit is setting on my breakfast table and it shows 73.7°
I put a sender in the workshop (#2) and one down under (#3).
Workshop is showing 48.3°. Local remote weather station shows 46°.
The down under is showing 54°...and i have nothing to compare it to.
What's really nice about this is ALL of the info is showing on one device - ALL at the same time.
All told, unit +batteries, I spent ~$43. The data is such a relief. (Knowledge is power!)
Opportunity has a shelf life.
have now had all of the sensors in place for a few weeks.
Sensor #1 is hanging right under the eve of the house.
Sensor #2 is hanging in the workshop
Sensor #3 is hanging about 1.5 ft in from the skirting (right under my kitchen at the water lines)
All three are reporting temps that are within 1° of the readings from other sources.
FWIW - one of the driving forces in putting these in place was to get away from leaving a faucet running so that a line doesn't freeze up. That's all good and fine - but with an electric water heater the water bill - AND the electric bill - were going up.
Sensor #1 is hanging right under the eve of the house.
Sensor #2 is hanging in the workshop
Sensor #3 is hanging about 1.5 ft in from the skirting (right under my kitchen at the water lines)
All three are reporting temps that are within 1° of the readings from other sources.
FWIW - one of the driving forces in putting these in place was to get away from leaving a faucet running so that a line doesn't freeze up. That's all good and fine - but with an electric water heater the water bill - AND the electric bill - were going up.
Opportunity has a shelf life.
As most everybody knows - Texas got caught in a full fledge winter freeze out that left many, many dead - and even more pipes busted with homes flooded. And i am sooooo very glad i installed those remote sensors.
I lost power for about 6 hours the first nite of the freeze. Man oh man - did it ever get frosty chilly freezin COLD! BUT! With the sensors in place, i could monitor the temp down under, and could do the 'trickle on' to keep the pipes from freezing up. It worked perfectly. My electric bill shot up a cool hundred - but i made it through it without a single burst pipe.
Most definitely worth the money!
I lost power for about 6 hours the first nite of the freeze. Man oh man - did it ever get frosty chilly freezin COLD! BUT! With the sensors in place, i could monitor the temp down under, and could do the 'trickle on' to keep the pipes from freezing up. It worked perfectly. My electric bill shot up a cool hundred - but i made it through it without a single burst pipe.
Most definitely worth the money!
Opportunity has a shelf life.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Why are faucets so sensitive with temperature adjustment?
by nestsman » Sat Jul 01, 2017 12:26 pm » in Mobile Home Repair - 2 Replies
- 6154 Views
-
Last post by stevieb
Mon Jul 03, 2017 3:21 pm
-
-
- 3 Replies
- 18001 Views
-
Last post by Greg
Tue Aug 13, 2019 6:21 pm
-
- 3 Replies
- 12407 Views
-
Last post by Greg
Sat Nov 16, 2019 7:17 pm
-
-
I need input on best way to hang new copper or pex pipes from underside mobilehome without opening up belly board
by waitingtohear » Mon Jun 11, 2018 12:21 am » in Mobile Home Repair - 7 Replies
- 89635 Views
-
Last post by waitingtohear
Mon Jul 02, 2018 5:39 pm
-
-
- 6 Replies
- 9261 Views
-
Last post by Mark440
Tue Aug 07, 2018 3:15 pm