I have yet to fix this. The pilot lights, the burner will light and burn for about 30-45 secs...then it slowly goes out. The blower comes on then and cycles, then goes off.
This is a propane set up and it just started this at the end of the winter/ what I tried so far..
New thermocouple
New valve, switched to LP
What else can I check before it gets cold again?
heater goes out
Brand and model number of furnace please. We cannot give any information with out these facts.
God, grant me the serenity
to accept the things I cannot change;
the courage to change the things I can;
and the wisdom to know the difference.
to accept the things I cannot change;
the courage to change the things I can;
and the wisdom to know the difference.
http://mobilehomerepair.com/phpbb/viewtopic.php?t=446
Time for a Tech to do some diagnostics to determine fault.
Take care and best wishes,
Robert
Time for a Tech to do some diagnostics to determine fault.
Take care and best wishes,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
As Robert said it would be best to let a professional visit your home and determine the true cause of your problem. Without the proper tools and knowledge you might replace many expensive parts and still not fix the problem. It is difficult to tell you what the problem is long distance. Sorry
God, grant me the serenity
to accept the things I cannot change;
the courage to change the things I can;
and the wisdom to know the difference.
to accept the things I cannot change;
the courage to change the things I can;
and the wisdom to know the difference.
Thanks, I have been reluctant to call someone. This is at our lake house and a long way from the service people. I am in far West Texas you see.
Hi,
I understand, however, there is nothing else that we can tell you to do DIY that hasn't been done.
Sometimes, a Tech with experience and tools/equipment is the only option left.
Take care and best wishes,
Robert
I understand, however, there is nothing else that we can tell you to do DIY that hasn't been done.
Sometimes, a Tech with experience and tools/equipment is the only option left.
Take care and best wishes,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49079 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 116444 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
-
Concrete foundation to keep mice out
by Asherjv15 » Thu Jan 02, 2020 5:00 pm » in Mobile Home Repair - 4 Replies
- 37350 Views
-
Last post by mdnagel
Wed Apr 22, 2020 1:14 pm
-
-
-
A message to the MH builders out there
by Mark440 » Sat Oct 10, 2020 1:37 pm » in Mobile Home Repair - 3 Replies
- 43167 Views
-
Last post by Mark440
Sat Oct 10, 2020 7:31 pm
-
-
-
Transformer burning out in an Evcon DES 80
by BigDave67s » Wed Dec 29, 2021 10:01 pm » in Coleman Service & Repair - 0 Replies
- 111979 Views
-
Last post by BigDave67s
Wed Dec 29, 2021 10:01 pm
-