Well I didn't know where else to ask for help it's been awhile since I've cheked out the forum recent projects include a 30 x 40 Muller building (self installed) and and abouve ground pool yea! Well we have been trash picking (too many repos in the neighborhood) we came across an Everglow PT-E4. The old fuel was glumpy and the wick was shot. I cleaned it up swished k-1 through it dumped all the gunk in the burn pit and installed the new wick. Worked like a charm but the wick was a little uneven so I readusted it and after about the fifth load of fuel it starts great guns burns clean the perforated sleave glows orange the flame is blue then after a few little while it just slows down keeps burning but very low BTW I have good vent under the kitchen door. Help?
Thanks
jennifer
O.K now it slows down and burns out all buy it's self the wick is clean soft no carbon it's like the wick can't get fuel, the tank is full the reservoir is full?
thanks
jenh
salvaged kerosene heater help
-
- Similar Topics
- Replies
- Views
- Last post
-
-
G.E.supplemental coil heater in wall unit
by stevenbrooks » Mon Jul 17, 2017 4:00 pm » in Service & Repair of Other Brands - 0 Replies
- 38634 Views
-
Last post by stevenbrooks
Mon Jul 17, 2017 4:00 pm
-
-
-
I am thinking of switching to a gas water heater
by deryk the gypsy » Sat Jul 22, 2017 7:16 am » in Mobile Home Repair - 2 Replies
- 39152 Views
-
Last post by Greg
Sat Jul 22, 2017 12:26 pm
-
-
-
Propane wall heater flickers badly
by nestsman » Tue Nov 28, 2017 1:23 pm » in Service & Repair of Other Brands - 2 Replies
- 33847 Views
-
Last post by suzy_dickson
Fri Jul 05, 2019 12:54 am
-
-
- 3 Replies
- 21263 Views
-
Last post by Greg
Sun Feb 25, 2018 9:49 am
-
-
heater blower intertherm feh-015ha-03
by newguy47 » Wed Oct 24, 2018 8:04 am » in Nordyne Service & Repair - 0 Replies
- 84799 Views
-
Last post by newguy47
Wed Oct 24, 2018 8:04 am
-