I bought a 1973 mobile home with 4'x12' ceiling panels made of fiberboard or what I would call flakeboard. Water damage that occurred before the roof was fixed created unrepairable sags in the ceiling panels, which are held up by rosettes 16" oc and thin strips of wood along the edges. I plan to remove the ceiling panels and replace them with lightweight 2'x4' ceiling panels made for a suspended ceiling, holding the new ceiling panels up by using long screws to hang rows of 1"x3" battens 2' oc perpendicular to the undersides of the trusses. With the battens in place, I would then insert the ceiling panels so that the battens would hold up their long, 4' edges, and then I would tighten the screws just enough to raise all of the panels to the same height. Where the 2' ends of the panels meet, I could caulk or glue them or just leave them as-is.
Does this plan seem sensible?
Once the rosettes are removed, should the old ceiling panels come down fairly easily?
replace fiberboard ceiling panels
Moderators: Greg, Mark, mhrAJ333, JD
You may find the ceiling panels are in place before the walls so there MAY be a problem getting the last inch or so free.
They may have also used glue to hold the panels too. It's really just a guessing game until you get into it.
Greg
They may have also used glue to hold the panels too. It's really just a guessing game until you get into it.
Greg
"If I can't fix it, I can screw it up so bad no one else can either."
Yes your plan seems sensible. The hard part is removal, and then leak location & repair. Installing new ceiling is relatively easy, as long as all damage inside is repaired. You may find that the paneling gussets have deteriorated, causing the ceiling-attachment edge of a truss to sag. New plywood gussets where needed, ensure all is level, make sure the vapor barrier is back in place, and you should be golden. Caulk and trim can forgive a lot of ugliness.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
'73 Viking Doublewide - Odd Ceiling Panels Hard to Remove
by 73Viking » Mon Dec 03, 2018 1:05 am » in Mobile Home Repair - 4 Replies
- 31200 Views
-
Last post by Greg
Mon Dec 10, 2018 5:34 pm
-
-
-
Metal exterior wall/ ceiling panels?
by Aarond8743 » Fri Feb 28, 2020 7:20 pm » in Mobile Home Repair - 3 Replies
- 15937 Views
-
Last post by Greg
Sun Mar 01, 2020 7:08 pm
-
-
-
Replace Roof Sheathing and Truss Question
by MandMLawson » Mon Aug 28, 2017 9:16 am » in Mobile Home Repair - 4 Replies
- 37166 Views
-
Last post by Jim from Canada
Wed Aug 30, 2017 10:09 am
-
-
- 0 Replies
- 13865 Views
-
Last post by Oregon101
Wed Mar 21, 2018 11:23 am
-
-
how do I replace a front door with built in storm door?
by truckinusa » Thu Oct 18, 2018 9:30 pm » in Mobile Home Repair - 0 Replies
- 35887 Views
-
Last post by truckinusa
Thu Oct 18, 2018 9:30 pm
-