Furnace won't ignite
Posted: Thu Oct 11, 2007 8:31 pm
Hey, It is me again. I found that the gas valve on the Duo Therm was bad and they don't make parts for them anymore. I found a used furnace, Coleman Evcon model # DGAA090BDTA, and installed it but have no owner's manual or any information about it. I got it all hooked up but when there is a call for heat, the little draft motor is all I hear coming on. I am not 100% sure I hooked up everything correctly but all I had to hook up was the gas, electricity, and the two wires from the thermostat. I am not sure how I could have messed that up. I can hear some clicking happening at the gas valve, but cycles on for a second and off, then a minute or so later it tries to cycle on but turns off, No flame. The thing finally shuts down and quits trying, and then the green lignt just flashes about 1 time every second or two. I don't know if it is just bad luck or what, but at least I should be able to get parts for this one.
Any help would be appreciated.
Thanks,
Wayne
Any help would be appreciated.
Thanks,
Wayne