Blend Air 2 system trouble
Posted: Sat Nov 03, 2007 12:23 am
I have a Blend air 2 system and had to replace the fan assembly up on the roof due to corrosion (I live near the ocean). That was two years ago.
Recently, the Blend air alarm came on and I used the trouble-shooting procedure on this site. It's a real help, by the way.
I traced the trouble down to the control board up on the motor/blower assembly on the roof. And I actually had saved the old one from when I did the replacement so I stuck that in and now it's working fine.
My question is this: the control board that I replaced was only two years old and looks in pristine shape since it was enclosed in that little box atop the blower assembly. Is this a problem area for these systems? Is there a warranty on this part?
The original worked for 5 years and is in use as I write this. (I'm going to replace it since that little four prong connector is a bit corroded even though I cleaned it up.)
Thanks.
Andy
Recently, the Blend air alarm came on and I used the trouble-shooting procedure on this site. It's a real help, by the way.
I traced the trouble down to the control board up on the motor/blower assembly on the roof. And I actually had saved the old one from when I did the replacement so I stuck that in and now it's working fine.
My question is this: the control board that I replaced was only two years old and looks in pristine shape since it was enclosed in that little box atop the blower assembly. Is this a problem area for these systems? Is there a warranty on this part?
The original worked for 5 years and is in use as I write this. (I'm going to replace it since that little four prong connector is a bit corroded even though I cleaned it up.)
Thanks.
Andy