Page 1 of 1

Coleman 7900 series furnace in 1988 mobile

Posted: Sat Nov 10, 2007 6:26 pm
by Austin
Hello —

My Coleman furnace is acting like the motor is running out of steam. Sometimes, the blower comes on without a problem. Other times, it gets going, but very slowly. And then sometimes, it just never comes on at all. In any case, it has recently started to smell 'hot' when it's running.

The original motor was replaced about five years ago and we change the filters at the start of every winter, so I can't imagine the 'new' motor has gone out already.

I opened it up and there was a lot of dust and collected junk in and around the motor (despite the filters!), so I cleaned it up a bit.

Does it need to be oiled? Or is there a bigger problem?

Thanks for any help.

~Austin

Posted: Sat Nov 10, 2007 9:31 pm
by hvac1000
Clean it up and try a new run capacitor for the motor.

RE: Coleman 7900 series furnace in 1988 mobile

Posted: Tue Nov 13, 2007 7:08 am
by Robert
You'll have to look at motor edges to see if it has oil ports. Also read the sticker on it, it should say if self lubricated or manually lubricated.


As for filters, change and/or clean them every 30 days.



Thanks,
Robert