mobilehomerepair.com

Hello! I have a Coleman Evcon 3500a816 unit. When the heat is not comanded on,the elements are staying warm. I wouldn't think that this is normal,is it? Any help would be greatly appreciated! Thanks!!!

Hi,

Most likely a bad sequencer. Yours needs Sequencer #3115-3571 @ $39.99 + $6.75 shipping.


It can be seen and ordered from right side here through PayPal:

http://www.mobilehomerepair.com/ColemanElec.html



OR, by calling toll free between 9AM/5PM CST to

1-877-263-7860 and charging to Visa or Mastercard.


More info needed before ordering if in Canada, so let us know.


Thanks,
Robert

Thank you for your help Robert!!! Much appreciated!

You're very welcome.


Thanks,
Robert

Robert,after a little more troubleshooting the problem was found to be a direct short to ground through one of the heating coils. The coil broke in two and fell down contacting the coil frame causing a short. My question is, given the model furnace I have which coil replacement do i need? Thanks, Grinny!

Yep, that can cause that as well, just not as common. Which element broke ?


Can you look on front plate and see what KW it is ?



Thanks,
Robert

Robert,it was the top element{of the two element slide in unit,3 elements total}.15.2kw. Ceramic isolator parts are all in good condition. I would need just the heating coil spring only. Thank you!

CORRECTION>>>>>It is a 9.6kw 240v 40amp element p/n 3500 410....Sorry!

Hi,

You can't get just the coil only, it comes as one complete unit with both new coils and two new limit switches.


Heating Element # 3500-410P/A @ $113.03 + $12.00 shipping.


It can be seen and ordered through PayPal from left side here:

http://www.mobilehomerepair.com/ColemanElec.html


OR, by calling toll free between 9A/5P CST Mon thru Fri to

1-877-263-7860 and charging to Visa or Mastercard.


If in Canada, let me know for added info for ordering.


Click on pic for enlarged view of the element.



Thanks for inquiring,
Robert