Page 1 of 1
gas coleman evcon
Posted: Tue Dec 18, 2007 7:44 pm
by Guest
The Furance wont light . The indacator light doesnt really flash,it goes off and on real fast . Sometimes you can flip the switch and it will run 1 time when it stops you have to knock power and start over. I was thinking control board what do you guys think .Thanks ps m#dgato70bdd electricman
RE: gas coleman evcon
Posted: Fri Dec 21, 2007 5:17 am
by Robert
Hi,
It should be showing a flash signal from one to six flashes/blinks.
When it doesn't work, does it do anything or does anything work on a call for heat ?
I wouldn't replace something as costly as a board without being sure.
Thanks,
Robert
RE: gas coleman evcon
Posted: Fri Dec 21, 2007 8:57 pm
by Guest
Robert, Thanks for your reply the light wasnt giving a study code more like a flashing . I changed the board and it is working ok. Thanks again for your reply.Im still new to the trade but learning more every day,with help from guys like you. THANKS A LOT :)
RE: gas coleman evcon
Posted: Sat Dec 22, 2007 3:33 am
by Robert
Hi,
That's great and you're very welcome. Hope all stays good to go with it.
Take care and best wishes,
Robert