Page 1 of 1
Replacing flexible crossover with sheet metal ducting.
Posted: Fri Jan 11, 2008 8:47 pm
by Silver Bullet 00
Has anyone replaced their flexible cross over duct on a DW with sheet metal ducting and not have to worry about rodents looking for a way in??
RE: Replacing flexible crossover with sheet metal ducting.
Posted: Fri Jan 11, 2008 10:12 pm
by Robert
Hi,
Yep, recommend it always and have for many years. Will be adding a new article on that in next month or so to our HVAC Articles section.
The second option is to install the two 90* ells and then stretch the flex tight across between them.
Keeping kinks out and off the ground will deter rodents greatly.
Also, keep the skirting sealed tight and underbelly as well.
Take care and best wishes,
Robert
Re: Replacing flexible crossover with sheet metal ducting.
Posted: Tue Jan 29, 2008 11:53 pm
by giancarlo.manrique
i dont but do you think i should do that !? send me a pm and please explain me what do i have to do ! thank a lot bye
Silver Bullet 00 wrote:Has anyone replaced their flexible cross over duct on a DW with sheet metal ducting and not have to worry about rodents looking for a way in??
RE: Replacing flexible crossover with sheet metal ducting.
Posted: Wed Jan 30, 2008 12:10 am
by Robert
2 - 90* hard metal ells and then hard metal duct across between them.
Wrap in insulation with outer vapor/moisture barrier.
Use sheet metal screws to connect and foil tape over seams.
Take care and best wishes,
Robert