Need Fault Codes for Coleman Evcon Furnace
I have a Evcon furnace model DGAA056BDTB and the cover plate for the controls box is missing. I am told that the fault codes were on the back of the plate. Where can I get a replacement cover or at least get the fault codes for my furnace?
Below should be the fault codes for your furnace.
Steady light on - normal operation.
One flash - ignition failure.
Two flashes - combustion air switch stuck closed.
Three flashes - combustion air switch failed to close.
Four flashes - limit switch open.
Five flashes - gas valve energized with no call for heat.
Rapid flashing - reversed polarity.
Note: Color of light is green.
Thanks,
Mark
Steady light on - normal operation.
One flash - ignition failure.
Two flashes - combustion air switch stuck closed.
Three flashes - combustion air switch failed to close.
Four flashes - limit switch open.
Five flashes - gas valve energized with no call for heat.
Rapid flashing - reversed polarity.
Note: Color of light is green.
Thanks,
Mark
You can't fail if you don't try!
Just wanted to add that you can get a cover from an old furnace of same /similar type being replaced at a HVAC shop.
Or, make one from sheet metal and attach with screws.
Thanks,
Robert
Or, make one from sheet metal and attach with screws.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
Thanks for stopping superczech.
You can't fail if you don't try!
-
- Similar Topics
- Replies
- Views
- Last post
-
-
I need wiring assistance for a miller furnace serial number A0981-0685
by Timodell » Wed Nov 20, 2019 10:40 pm » in Nordyne Service & Repair - 0 Replies
- 65696 Views
-
Last post by Timodell
Wed Nov 20, 2019 10:40 pm
-
-
-
Colman evcon presidental 7980B856 furnace will not stay on
by ezridersid » Sat Dec 21, 2019 8:52 pm » in Mobile Home Repair - 1 Replies
- 17306 Views
-
Last post by ezridersid
Sat Dec 21, 2019 9:04 pm
-
-
- 0 Replies
- 110046 Views
-
Last post by cwwhite75
Sat Feb 29, 2020 8:46 am
-
-
Need advice on blower
by NorthTexasSafariGuy » Mon Jul 31, 2017 9:18 am » in Coleman Service & Repair - 0 Replies
- 70624 Views
-
Last post by NorthTexasSafariGuy
Mon Jul 31, 2017 9:18 am
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49079 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-