Intertherm E1EH-015
Posted: Sat Jan 19, 2008 4:30 pm
I have a 10 year old Intertherm furnace that has worked great during its lifetime. It did stop working about 2 years ago, and thanks to this website I found that the problem was a defective sequencer that I ordered and replaced. This winter the furnace stopped working again, doing the same thing: clicking on, the element heats up to a glowing red, then it clicks off. So, I was again ordered a sequencer (621383) and replaced it. The furnace worked fine again until last week when it stopped again. I thought it was rather fast for a sequencer to go out, ordered two more from this site, just in case one goes out again I can replace it right away. I got the sequencers on Thursday, replaced it, an it worked again. By Friday morning it was not working again. I am thinking there is something else going on, but not sure what it might be.
The furnace goes through its start up, the elements heat up, and then it clicks off--the blower never engages. It then clicks back on, the element heats up, then clicks back off again...
What else could be doing this? Could it be the other sequencer--the 2-Pole Blower Timing (621596)? Or is there something overloading the 1-Pole Aux Timing sequencer I keep replacing?
Any help would be appreciated. Thank you.
The furnace goes through its start up, the elements heat up, and then it clicks off--the blower never engages. It then clicks back on, the element heats up, then clicks back off again...
What else could be doing this? Could it be the other sequencer--the 2-Pole Blower Timing (621596)? Or is there something overloading the 1-Pole Aux Timing sequencer I keep replacing?
Any help would be appreciated. Thank you.