Good morning guys:
My 2004ish model DGAA056BDTA furnace is not firing.
Serial number #020701058
I have a steady on green light on the fault panel. -which indicates no problems right?-
When I turn the thermostat up, nothing happens to the furnace, however when I turn the switch from heat to off to heat again, the furnace starts cycling for about 3 minutes then shuts off again.
It also appears that I do not have any sort of pilot light or ignition source. Could the ignition source switch be bad?
any suggestions?
Furnace has never acted up like this before.
Michael J. Cheaney
Pewaukee WI.
Coleman model DGAA056BDTA Not firing
Hi Michael,
Could be the circuit board, t-stat, etc... . You would need to test with a meter to determine if power is reaching each component.
Thanks,
Robert
Could be the circuit board, t-stat, etc... . You would need to test with a meter to determine if power is reaching each component.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 116444 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
-
Nordyne model m1mb 070a bw power issue
by Combustibleink » Mon Nov 16, 2020 10:21 am » in Nordyne Service & Repair - 0 Replies
- 116111 Views
-
Last post by Combustibleink
Mon Nov 16, 2020 10:21 am
-
-
-
Evcon Heat Pump - Air Conditioner Model No. BRHS036B Making HUM Before Starting
by Dave_L » Tue Aug 29, 2023 1:26 am » in Coleman Service & Repair - 0 Replies
- 126535 Views
-
Last post by Dave_L
Tue Aug 29, 2023 1:26 am
-
-
-
Model DGAA070BDTA venting kit needed.
by spazatac » Fri May 24, 2024 11:21 am » in Coleman Service & Repair - 2 Replies
- 703 Views
-
Last post by spazatac
Mon Jun 10, 2024 3:11 pm
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74894 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-