Page 1 of 1
Coleman presidential
Posted: Mon Jan 28, 2008 4:25 pm
by ACxtreme
I have a coleman presidential, model no 6806-732, have had no prior problems, but now the heater does not kick on. I checked for proper current to the heater breakers and going out. All was good and the the transformer is buzzing. When i turn the thermostat up or down I do not get a click like it used to, could the stat be out? how do i check?
Thanks in advance
LA
RE: Coleman presidential
Posted: Mon Jan 28, 2008 7:08 pm
by ACxtreme
I have figured out the stat must be bad but looking at the connections at the point where the wires all connect at the heater on a isolator board of some kind just before going into the breakers on the heater, this panel or board is cracked and falling apart, where can i get one of these???
Thanks
Again
LA
RE: Coleman presidential
Posted: Mon Jan 28, 2008 7:47 pm
by Robert
Did you test the transformer for proper voltage ?
Did you test at t-stat for proper voltage ?
Those terminal boards are no longer available.
Will need to repair with wire nuts or molex connector plugs.
Thanks,
Robert