Hi Robert,
No, I don't have a wiring diagram! That would have been a good piece of paper to have included with the numerous other papers sent with the unit. But alas - that wasn't one of the "importiant documents" included with my furnace.
I should have taken a picture of the wires before attempting to replace the parts. So, being in a hurry to get the parts installed I went ahead without the picture. Now - my haste is causing a further delay. Does stupid sound applicable?
I believe that if the sequencer wiring can be correctly configured everything will be accomplished. To that end the sequencer has terminals labled:
M1 (2 connections) M1a M1b
M2 ( 2 connections) M2a M2b
M3
M4
H1 ( 2 connections) H1a H1b
H2 (2 connections) H2a H2b
I have present the following 10 wires expressed by origin terminal and color:
From the breaker:
Black wire (hot) side, 2 Orange wires
they, for sure, attach to the limit switches on the element panel
does it matter which one either goes too? I suspect it does not.
White wire (neutral) side, 2 yellow wires
Suspect terminal M1 Does it matter which side they are on? I don't believe it does.
M3 Suspect connection to the
Thermostat control switch - yellow wire
M4 Suspect connection to
thermostat control switch- blue wire
H1 2 connections
H1a suspect connection to:
orange wire from transformer
H1b suspect connection to:
black wire from transformer
H2 (2 connections)
H2a suspect connection to
white wire from transformer
H2b suspect connection to
yellow wire from transformer
The picture shown on the web site
HTTP://WWW.mobilehomerepair.com/media/i ... 0-3571.jpg
shows the picture of my sequencer switch
H2 is shown on the bottom plate having two connections the closest one I labeled H2a
the further one H2b
above that terminal on the same side is found M3 (one connection)
above M3 is M4 (2 connections)
M1a is closest
M1b is father away
on the other side of the sequencer switch mounting plate is
H1 (2 connections)
H1a is closest
H1b is farther away
above H1 is
M4 (one connection)
Above M4 is M2 (2 connections)
M2a is closest
M2b is father away
I realize this information is perhaps not the most discernable for you to decipher. I rely on your extensive knowledge and experience to - hopefully - help me put this thing back together! If there is any way I could better describe the wiring or if you have any questions I'd be so happy to answer them and hopefully "get er done!"
Thank you VERY MUCH for your help with this simple project I screwed up so badly! A simple digital picture in the beginning would have allowed me to very quickly reattached the wires without any further thought on the matter. Now - I need your expertice - very much - in order to remedy my stupidity and the lack of information avaliable from Coleman - or whatever they are being called now.
I hope you can get back with me soon as the weather is nice - for the present time but heat will be needed at night and most likely AC during the afternoons in the next few days.
Thanks again! GOD BLESS YOU!!!!!
Norbert