Now that I have a doorwall off the kitchen, I want to build a deck along the back of the home.
I would like to attach the deck to the home with a band board along the base of the home. Is this a feasible method? If so, what should I use to attach the band boards? How far will a lag screw go in? Will I hit metal?
Or will I need to free float the deck. If so, I won't be able to replace the siding on the home like I want to because I wouldn't have easy access to what is behind the framing of the deck.
Jeff
www.tastyvenison.com/Rancho_Pequeno.htm
Attaching a deck
Moderators: Greg, Mark, mhrAJ333, JD
The day you stop learning is the day you start dying.
I am planning my materials list as though it will be a free standing deck.
My intention is to replace the vinyl siding of the home with a stained hardiplank. If I free float the deck, there's no way to get back behind the deck to remove the vinyl siding once I have the deck up (it will be 44 feet long).
I am guessing that I will need to replace the first row of siding with the hardiplank then put up the deck. I don't know when I will get around to finishing the balance of the hardiplank project but hopefully it won't be too long.
On typical construction I would lag screw the band boards to the floor frame of the home and dispense with supports next to the home but from what you explain, this must not be an option so I will go the circuitous route.
Jeff
My intention is to replace the vinyl siding of the home with a stained hardiplank. If I free float the deck, there's no way to get back behind the deck to remove the vinyl siding once I have the deck up (it will be 44 feet long).
I am guessing that I will need to replace the first row of siding with the hardiplank then put up the deck. I don't know when I will get around to finishing the balance of the hardiplank project but hopefully it won't be too long.
On typical construction I would lag screw the band boards to the floor frame of the home and dispense with supports next to the home but from what you explain, this must not be an option so I will go the circuitous route.
Jeff
The day you stop learning is the day you start dying.
Hi Jeff,
Yanita is probably right about the code issue. We have areas here that are basically on granite, but code still says no attached structures. It would be better for your home as well. Without an actual foundation under the wall, any additional weight would be hanging off the wall. This would also go for for any roof you eventually put over the deck. An aluminum awning is light weight and flexible enough to be attached, where a wood awning should be free standing.
JD
Yanita is probably right about the code issue. We have areas here that are basically on granite, but code still says no attached structures. It would be better for your home as well. Without an actual foundation under the wall, any additional weight would be hanging off the wall. This would also go for for any roof you eventually put over the deck. An aluminum awning is light weight and flexible enough to be attached, where a wood awning should be free standing.
JD
☯JD♫
Today is PERFECT!
All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.
Today is PERFECT!
All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.
We don't have any plans for a roof, so that part is easy. I'll just have to do the first row of hardiplank siding before I start the project.
It will look a little awkward until I get around to the balance of the siding but that's just how it will have to be.
I think at the same time, I will put a small covered porch on the front of the home to get us out of the elements before we go into the home. I think I will follow the fllow of the peak on the front and extend out from there.
Jeff
It will look a little awkward until I get around to the balance of the siding but that's just how it will have to be.
I think at the same time, I will put a small covered porch on the front of the home to get us out of the elements before we go into the home. I think I will follow the fllow of the peak on the front and extend out from there.
Jeff
The day you stop learning is the day you start dying.
If it were me, I would drop down a couple of inches on the fascia board for the door awning. The flashing can slide up under the roof's edge metal. Makes for a nice installation and is easy to seal against leaks where the cover meets the roof.
JD
JD
☯JD♫
Today is PERFECT!
All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.
Today is PERFECT!
All information and advice given is for entertainment and informational purposes only. The person doing the work is solely responsible to insure that their work complies with their local building code and OSHA safety regulations.
Excellent suggestion, thank you.
The day you stop learning is the day you start dying.
- Brenda (OH)
- Posts: 325
- Joined: Sun Apr 01, 2007 7:57 am
this may seem strange, but if you save the vinyl siding after you remove, install the handiplank, and just do a temporary install of the vinyl on top of the handiplank in such a way that you can get it off easily (removable caulk? minimum number of roofing nails?) would that look better than the single row of handiplank awaiting the rest of the rehab? in other words, camouflage!!! and if the last word is mispelled,sorry, I did try the spell checker!
Brenda (OH)
Brenda (OH)
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Attaching triple 2x6 floor joist to rim joist
by mdnagel » Mon Aug 19, 2019 10:06 am » in Mobile Home Repair - 2 Replies
- 23596 Views
-
Last post by mdnagel
Wed Aug 21, 2019 10:42 pm
-
-
-
New Deck and Porch coming (photos included)
by vilmel2vilmel2 » Mon Jul 17, 2017 5:58 pm » in Mobile Home Repair - 4 Replies
- 44265 Views
-
Last post by vilmel2vilmel2
Wed Aug 02, 2017 10:29 am
-
-
-
Fixing a rim joist with a deck atached
by 95doublewide » Thu Apr 04, 2019 7:00 pm » in Mobile Home Repair - 1 Replies
- 28788 Views
-
Last post by Greg
Fri Apr 05, 2019 8:07 am
-
-
-
Deck footing and porch design questions
by mdnagel » Thu Aug 15, 2019 1:28 pm » in Mobile Home Repair - 6 Replies
- 33274 Views
-
Last post by mdnagel
Tue Aug 20, 2019 6:44 pm
-
-
- 2 Replies
- 15194 Views
-
Last post by mdnagel
Wed Apr 22, 2020 4:13 pm