I recently replaced the thermocouple in my Coleman furnace via this website ( thanx) but the wind in Amarillo is a bitch. When it gusts it blow out my pilot and I must wait until the wind subsides to relight it.
I climbed on the roof to check it out and it looks like an adequate pflumm or chimney or whatever. It looks like a tin can hourglass. I can take & upload a picture if it would help.
I would appreciate any advice.
Thank You!
Angie
Wind Blowing Pilot Out
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Ducts barely blowing - what to check first?
by caligirl » Fri Nov 25, 2022 1:21 pm » in All Other HVAC Questions - 0 Replies
- 112993 Views
-
Last post by caligirl
Fri Nov 25, 2022 1:21 pm
-
-
-
intertherm standing pilot propane burner Heat Rise of 38°F spread.
by justplumducky » Fri Aug 25, 2017 10:06 am » in Nordyne Service & Repair - 0 Replies
- 55122 Views
-
Last post by justplumducky
Fri Aug 25, 2017 10:06 am
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74898 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49082 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 116446 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-