Page 1 of 1
Thermostat heat anticipator setting?
Posted: Fri Jan 23, 2009 7:03 am
by johnrock11j
What is a good setting for the heat anticipator? Is there any rule of thumb for where it should be set or is it kinda of wing it thing? Thanks :?:
Posted: Fri Jan 23, 2009 10:27 am
by flcruising
What type of thermostat and furnace?
If gas furnace, you typically match the milliamp draw of the gas valve, then adjust incrementally (shorter or longer) from there depending what cycle frequency you're aiming for.
RE: Thermostat heat anticipator setting?
Posted: Thu Jan 29, 2009 8:27 pm
by johnrock11j
Intertherm Gas furnace and Intertherm thermostat.
RE: Thermostat heat anticipator setting?
Posted: Fri Jan 30, 2009 4:52 pm
by Robert
Look in your furnace manual or on the gas valve for the anticipator amp setting, then set accordingly and leave it there.
Needs to be set to manufacturer design specs and left there with no adjustments needed.
Thanks,
Robert