Page 1 of 1
Do they make flatter batten strips?
Posted: Tue Mar 24, 2009 12:26 am
by marriednamobile
If I don't go the mud, tape, caulk, etc.. way, I'd be perfectly happy with some thinner batten strips that don't stick out as much.
Is this a possibility?
RE: Do they make flatter batten strips?
Posted: Tue Mar 24, 2009 6:59 am
by Rod
You could try screen molding. I don't know if its really thinner but its not as wide. Install them before you paint. Use a paintable silicone/caulk along the edges to hide the dark line/shadow. Hopefully it will help to make them less noticeable.
Good Luck
Rod
Posted: Tue Mar 24, 2009 8:17 am
by flcruising
When we were home shopping, we went into one make (can't remember the name) that had flaps that stuck over the joint. Basically the paper from one wall board extended about an inch past itself and lapped over and stuck to the next one. We didn't mind that look at all. Matching up a particular print after-the-fact though may be difficult.
RE: Do they make flatter batten strips?
Posted: Thu Mar 26, 2009 1:18 am
by marriednamobile
ooh the screen molding sounds like a good idea, I'm going to check that out
Posted: Thu Mar 26, 2009 9:05 am
by blbrade1
u could also try an expansion joint they sell them at home repair stores if u dont mind seeing a gap at each joint this may be a possibility