Page 1 of 1
Need PICTURE for Intertherm furnace FEH-015HA wiring diagram
Posted: Sun Nov 15, 2009 12:14 am
by Kris
I recently purchased 3 new restring kits, 2 new limit switches, and 4 new fuses. However, I failed to take a picture of how the wiring was connected before I took it apart.
I have the diagram on the inside of the door, but I am too chicken to fire the furnace up because I second guess myself constantly.
Does anyone have, or could they take a picture of their wiring so I don't have to buy everything AGAIN?!
Thanks in advance for the help.
Kris
Re: Need PICTURE for Intertherm furnace FEH-015HA wiring diagram
Posted: Sun Nov 15, 2009 10:54 pm
by Robert
Hi Kris,
Trust the wiring diagram, IF your wires match the diagram, all is ok.
A picture of someone's furnace could be a picture of some modified or wrong wiring.
The wiring diagram is correct.
Left side of each coil has a wire to a sequencer spade terminal.
Right side of each coil has a short wire to the limit, then onto the fuse.
Trace each one by one, match to the diagram and all will be fine.
Thanks,
Robert
Re: Need PICTURE for Intertherm furnace FEH-015HA wiring diagram
Posted: Sun Nov 15, 2009 11:12 pm
by Kris
Thanks for the quick reply. As it turns out, I actually got it running last night. The problem turned out to be..... I had the elements in upside down!
Once I figured it out, it went together fairly quickly.
Now all I need to do is figure out how to clean out my ductwork as my furnace hasn't ran in about two years. I used a mirror and a flashlight, and it kind of looks like Mammoth Cave down there.......
Re: Need PICTURE for Intertherm furnace FEH-015HA wiring diagram
Posted: Mon Nov 16, 2009 1:03 am
by Robert
Hi Kris,
Be VERY careful cleaning mobile home ducts. They are made of thin, flimsy aluminum and rip and tear apart very easily.
IF that happens, a mammoth cave would be least of your worries.
Glad you got the heat going. You're very welcome, happy to help.
Take care and best wishes,
Robert