Page 1 of 1
Nordyne KG6RC-060C Blown Fuse
Posted: Tue Nov 17, 2009 8:55 am
by greypower
My furnace quit working last night, and I discovered that the 3A fuse on the control board was blown. I replaced the fuse and it blew again after a few seconds. Before the replacement fuse blew, the red LED indicator light blinked once. Any thoughts?
Re: Nordyne KG6RC-060C Blown Fuse
Posted: Wed Nov 18, 2009 2:46 am
by Robert
Hi,
This is what is needed for troubleshooting:
http://www.hvacpartstore.com/product_de ... cts_id=297
OR, quite a few 3A fuses. Turn power to furnace OFF.Take the wire off the R at board. Then remove wire from W.
Get a small jumper wire and connect it across R and W at board.
Restore power and see if fuse blows.
Let me know what results are.
Thanks,
Robert