Coleman DGATO56BDD circuit board

[brianz]

I have a Coleman Exvon DGATO56BDD nat gas furnace. It has power, Vom says 25v out of Xformer and 120v line. Circuit board had gotten wet and shows a little dried rust. Could this have killed the board? I suspect it should have a solid green light when powered up? The 3 amp fuse checks ok.
Is there a list of voltages or some other troubleshooting info anywhere? I'd like to confirm that a new board would not also fry. ....and can you point me to a source for the replacement board

Thanks for any help!

[Robert]

Hi,

We have the parts if needed. The board would need to be tested for power in and out as needed according to wiring diagram.


I offer step troubleshooting help through email for $20.00 if needed here:

http://www.mobilehomerepair.com/Order4b.html




Thanks,
Robert