furnace problem
I have a Coleman DGAA077BDTA that I am not sure is running right. I can here the propane burning for a full minute before the blower comes on. The blower comes on and runs for a full two minutes, then the furnace shuts off for a full minute then repeats the same cycle over again. I have tried changing the cycle time on the thermostat but it has no effect, it will still run the same way. Is this normal? I dont have the money to have someone come out and check it. There is a green light on the furnace that stays lit, and I have checked it several time and have never noticed it blinking or going off.
Check the main burner orifice/spud behind the gas valve to see if there are any blockages (spider/web/eggs).
Check burner tube to ensure it is clean and clear.
Thanks,
Robert
Check burner tube to ensure it is clean and clear.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
Hi,
Don't have a pic on hand, it is at the back of the gas valve and attaches to the gas valve. Long or short pipe with a burner orifice inside that controls gas pressure to burner.
If unknowledgeable about this, best to let an hvac tech inspect it for you.
Thanks,
Robert
Don't have a pic on hand, it is at the back of the gas valve and attaches to the gas valve. Long or short pipe with a burner orifice inside that controls gas pressure to burner.
If unknowledgeable about this, best to let an hvac tech inspect it for you.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
DGAT Series furnace air-conditioning issue
by minnie1967 » Thu Jul 13, 2017 9:48 am » in Coleman Service & Repair - 0 Replies
- 61995 Views
-
Last post by minnie1967
Thu Jul 13, 2017 9:48 am
-
-
-
Acceptable HEAT RISE number for this 20-yr. old furnace.
by justplumducky » Tue Aug 29, 2017 5:33 pm » in Nordyne Service & Repair - 0 Replies
- 44475 Views
-
Last post by justplumducky
Tue Aug 29, 2017 5:33 pm
-
-
-
Can't get the furnace cover to go on
by nestsman » Sat Sep 30, 2017 4:53 pm » in Nordyne Service & Repair - 2 Replies
- 48526 Views
-
Last post by tkrueger
Sat May 05, 2018 9:12 pm
-
-
- 0 Replies
- 25204 Views
-
Last post by jrpells2017
Wed Nov 08, 2017 8:58 am
-
- 0 Replies
- 30629 Views
-
Last post by Carl Wofford
Sat Jan 20, 2018 6:55 pm