I replaced the blower motor last week (7966-311P Blower Motor). Hook up was straight forward but now with the furnace on (normalized) thermostat not engaged the motor is hot to the touch. Limit switch is OK. With the furnace running the motor is cool to the touch due to the volume of air flowing by it which makes sense but what doesn't make sense is how hot the motor is when the blower is off.
This doesn't seem normal to me and I would think no power to the motor till the furnace kicks.
Does that sound right?
Thanks
JC
Coleman Heater 7966A856 Blower Motor Hot
After looking at the furnace I've concluded that the motor is operating normally. With the furnace off the motor is at room temp. After the furnace runs and shuts off the motor immediatley feels cool due to the volume of air flow but then heats up to considerably before a gradual cool down.
I'm going to assume this in normal.
I'm going to assume this in normal.
Hi,
Depends on how hot it is and how quickly it cools down. Should never be too hot to lay hand on.
Thanks,
Robert
Depends on how hot it is and how quickly it cools down. Should never be too hot to lay hand on.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
- 0 Replies
- 25777 Views
-
Last post by Tonystark
Fri Dec 07, 2018 12:30 pm
-
-
heater blower intertherm feh-015ha-03
by newguy47 » Wed Oct 24, 2018 8:04 am » in Nordyne Service & Repair - 0 Replies
- 84872 Views
-
Last post by newguy47
Wed Oct 24, 2018 8:04 am
-
-
- 4 Replies
- 9775 Views
-
Last post by Cherry_bomb
Thu Aug 17, 2017 11:28 am
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74957 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
- 0 Replies
- 57616 Views
-
Last post by Montanan
Wed Jan 03, 2018 1:03 pm