I have a 1700 sq ft MH. Last summer the AC evap started freezing up. After replacing filters, cleaning coils, it was determined that the freon level was low. The house and hvac system is 18 years old. I am in the market for a package unit gas pack. I am also on a fixed income, (retirement). I have a mechanical background and did install a gas fired boiler in a previous house. The models that I'm looking at,(Goodman and Rheem 3 ton 90,000 btu) have a square to round adapter using 14" ducting. I located a filter box for the inlet, (where the current gas furnace is sitting), so I can use the 14" duct to that box. The house has rectangular duct work however. Question is, can the flexible duct be re-configure to slip over the existing rectangle duct or will I have to purchase a "round to rectangle" adapter to tie in the two? If so where can these adapters be found?
I am new to this website and have found it to be very informative.
Gas Pack Installation
Hi,
Call Mark toll free at 1-877-263-7860. He should have it in stock or be able to get it quickly.
It is a supply duct connector adapter collar that you have to cut out the duct to attach it.
Thanks,
Robert
Call Mark toll free at 1-877-263-7860. He should have it in stock or be able to get it quickly.
It is a supply duct connector adapter collar that you have to cut out the duct to attach it.
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Question about installation over existing floor
by Stormymonday » Sat Sep 15, 2018 3:06 pm » in Off Topic Discussions - 1 Replies
- 27811 Views
-
Last post by Greg
Fri Sep 21, 2018 7:08 pm
-
-
-
I am thinking of switching to a gas water heater
by deryk the gypsy » Sat Jul 22, 2017 7:16 am » in Mobile Home Repair - 2 Replies
- 39152 Views
-
Last post by Greg
Sat Jul 22, 2017 12:26 pm
-
-
-
Need to remove a stripped Allen wrench-type plug from the OUT PRESS port on top of gas valve
by justplumducky » Fri Aug 25, 2017 8:21 am » in Nordyne Service & Repair - 1 Replies
- 49072 Views
-
Last post by Maxwell.lipphardt
Mon Feb 04, 2019 6:29 am
-
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74890 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
- 0 Replies
- 42043 Views
-
Last post by David DeBord
Sun Oct 22, 2017 7:13 am