Hello, I have a Coleman eb23b electric furnace. When using the heat the output is lukewarm 85-90 degrees. When I remove the air filter or access pannel the output is hot around 150 degrees. Once I reinstall the pannel and filter I can hear three clicks which I am assuming are the limit switches. I have cleaned the evaporator core and removed and cleaned the blower and squirrel cage. All of my registers are open all the way. And I have changed the filter from a Merv 7 to a less restrictive merv 2 filter. What do you you think is going on? Is it common for 3 limit switches to go bad at the same time?
Thanks, Kyle
Coleman eb23b not enough heat
Change to a fibered hogs hair filter. You can get them at hvac supplies, some wal-marts and by calling Mark's store at 605-229-2627.
Thanks,
Robert
Thanks,
Robert
Some people are Humbly Grateful, while some are Grumbly Hateful.................... Which one are you ?
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Heat strips are on, but not the fan.
by Forestbrook » Sat Dec 08, 2018 6:09 pm » in Coleman Service & Repair - 0 Replies
- 42150 Views
-
Last post by Forestbrook
Sat Dec 08, 2018 6:09 pm
-
-
- 0 Replies
- 28088 Views
-
Last post by bjwag123
Thu Oct 10, 2019 12:08 pm
-
-
Intertherm standing pilot LPG burner 77 BTU IN gas valve mounting plate gets hot ( not warm).
by justplumducky » Sat Sep 09, 2017 3:34 am » in Nordyne Service & Repair - 1 Replies
- 74895 Views
-
Last post by Maxwell.lipphardt
Thu Nov 22, 2018 10:15 am
-
-
-
Intertherm outdoor a/c unit, blower not turning off. Model unknown rating plate is faded out.
by tkrueger » Sat May 05, 2018 8:57 pm » in Nordyne Service & Repair - 0 Replies
- 116444 Views
-
Last post by tkrueger
Sat May 05, 2018 8:57 pm
-
-
- 2 Replies
- 27493 Views
-
Last post by plumducky
Tue Dec 10, 2019 3:59 pm