mobilehomerepair.com

I have a coleman furnace model number DGAA070BDTA. The inducer is locked up and I am changing it out. How do I get it out? The motor is inside the vent pipe. The section that it is is in appears to be glued to the sections on each end of it. Also there is no free movement of the entire vent pipe to even try to seperate it. Thank you.

Remove screws from outer edge of assembly, not gas valve part, but the larger outer assembly.

Then remove that, lift up on air pipe above the shelf edge, then slide down and out.

Remove tubes and wires first.


Thanks,
Robert