Page 1 of 1
Replacing Booster Motor
Posted: Wed Dec 08, 2010 7:02 pm
by andyr78
Hello I have a Coleman Evcon DGAT090BDD furnace and will be replacing the booster motor this weekend. I am purchasing the part that was recommended on this site about 2 months ago.
http://www.aberdeenhomerepair.com/store ... ster-motor
I just wanted to make sure before I started that I wouldn't need any special tools to get this thing replaced.
Thank you
Re: Replacing Booster Motor
Posted: Sat Dec 11, 2010 12:07 am
by andyr78
I successfully replaced the booster motor today. Thank you for your help and suggestion for the part. The guys at Aberdeen were very good and delivered what they promised. Once again thanks for your help. I am sure I saved a lot of money doing this myself.
Re: Replacing Booster Motor
Posted: Sun Dec 12, 2010 1:00 am
by Robert
Hi,
You're very welcome, happy to help. Glad all went well. Sorry I was not available sooner, I had knee surgery Tuesday and been recovering and down for a bit.
Thanks,
Robert
Re: Replacing Booster Motor
Posted: Sun Dec 19, 2010 2:35 pm
by andyr78
Not a problem, I just appreciate the help. If I had to make one suggestion for anyone trying this. Make sure you have a long handle screw driver. One of the screws are pretty hard to get to without one.
Re: Replacing Booster Motor
Posted: Mon Dec 20, 2010 1:43 am
by Robert
You're very welcome, happy to help. That does happen at times, glad you got it taken care of.
Thanks,
Robert