Page 3 of 3
Re: UPDATED**Nordyne/ No heat in auto-only in vent mode??
Posted: Wed Dec 30, 2009 1:49 pm
by Ereed2
Hello Robert! Finally got around to doing this and this still does not work. I removed the yellow wire and plugged in in where the red wire is as you said and I still have no heat and no motor run in Auto-Heat mode?? I am out of ideas, not sure its the motor anymore?
Re: UPDATED**Nordyne/ No heat in auto-only in vent mode??
Posted: Thu Dec 31, 2009 1:58 am
by Robert
IF there is power to the motor there, it should run if it's ok.
Thanks,
Robert
Re: UPDATED**Nordyne/ No heat in auto-only in vent mode??
Posted: Wed Jan 06, 2010 3:17 pm
by Ereed2
Robert, I have power there (240VAC) but no motor? I swapped the yellow wire for the red wire at the molex plug at the motor and call for heat and still no blower?
Re: UPDATED**Nordyne/ No heat in auto-only in vent mode??
Posted: Thu Jan 07, 2010 5:57 pm
by Robert
Hi,
IF there is 240vac at the molex plug and through it and motor will not run when you spin the wheel with a call for heat, then the motor is bad.
Thanks,
Robert