Page 1 of 1
Coleman DGAA070BDTA Flame goes out as soon as blower starts
Posted: Sat Feb 06, 2010 12:00 pm
by johnrich
I have a Coleman DGAA070BDTA Propane furnace. It has worked all winter until this morning. When turning it on, after around ten seconds I can see it start to glow through the view hole. After around 5-10 more seconds the flames appear. After around 15 seconds more the blower kicks on and the flames go out. Any suggestions would be greatly appreciated. Thanks!
Re: Coleman DGAA070BDTA Flame goes out as soon as blower starts
Posted: Sat Feb 06, 2010 10:17 pm
by johnrich
Actually, I found out what the problem was. We had tremendous snow fall last night and and piled up around the flue vent and it wasn't getting enough oxygen. Once I cleared the snow off the roof around the flue, it started working fine again.
Re: Coleman DGAA070BDTA Flame goes out as soon as blower starts
Posted: Wed Feb 10, 2010 2:52 am
by Robert
Glad you got it taken care of.
Thanks,
Robert