Page 1 of 1
Coleman Evcon BRC80361CB Capacitor connection
Posted: Mon May 24, 2010 7:01 pm
by phatkhat
The wiring diagram has been eaten by little bugs, and I need to replace the capacitor. There are three wires, brown, red and white, but I don't know which one goes to which connection. The capacitor has a two pronged, a three pronged, and a four pronged connector, but the wires only have a single clip on each one, so I don't know which color goes to which connector. I was careless and didn't tag my wires...
HELP!!!
Re: Coleman Evcon BRC80361CB Capacitor connection
Posted: Mon May 24, 2010 10:59 pm
by Robert
Hi,
Double check this and see if it is right.
Red = HERM
Brown = FAN
White = Common (unmarked)
Trace each wire and go by this in case above don't match this:
Compressor wire = HERM (Red ?)
Fan wire = FAN (Brown ?)
Contactor wire = Common (unmarked) (White ?)
Thanks,
Robert
Re: Coleman Evcon BRC80361CB Capacitor connection
Posted: Mon May 24, 2010 11:49 pm
by phatkhat
Thanks very much! And on a fragment of the diagram, they had a fan wire brown, so I do believe this is just what I needed! The capacitor is labeled as you say on the terminals. And I will sure label the wires, too. I know better than to think I can remember anything important, LOL.
Re: Coleman Evcon BRC80361CB Capacitor connection
Posted: Tue May 25, 2010 12:18 am
by Robert
You're very welcome, happy to help.
Thanks,
Robert